Servicing the Northern Wisconsin area, Kramer Well Drilling has been in operation drilling quality wells since 1924. We have the capability to do residential and commercial well drilling projects. We enjoy a reputation of quality work, great customer service, honesty and friendly employees and we are very proud of that. We invite you to explore our site to learn more about our business and about the well drilling process. Servicing the Northern Wisconsin area and Based in Weyerhaeuser, Wisconsin and services these general areas: Ladysmith, Bruce, Rice Lake, Barron, Eau Claire, Chetek, Cameron, Chippewa Falls, Hawkins, Holcombe, Cornell, Bloomer, Park Falls, Phillips, and many more. By staying ahead of the latest technologies and conforming to all current licensing and well drilling regulations, we strive to be the best! With 90 years experience, in the business have earned the reputation of providing top quality well and pump installation for all of your water needs.
Kramer will obtain all the necessary permits for your well installation. State and county codes are strictly followed to assure proper and long lasting performance and quality of your well.
We meet with the owner/builder to choose a site that meets all code requirements. The drill crew will bring the rig in and set it up. We start by sliding the first rod with the drill bit on into the first piece of casing. We then hook a winch cable to it and bring the rod and casing to the top head and connect it. Then we weld a hardened drive shoe to the casing so it does not damage the end. We then set the hydraulic casing hammer on top, engage the top head and air compressor then start drilling.
As we continue down with the well casing we check to see where the static water table is. Once we know that, then we have to go 10′ into it then start looking to see if we have the right material to make a well. When we talk about material we mean clean sand or clean sand and gravel. We cannot make a well out of clay or silt because it will plug the well screen.
Once we are done drilling we then pull our rods and set a well screen. Then we develop the well out with air, set a test pump and check the quantity and quality of water.
When drilling a well, certain applications are different than others. Some will require a screen and some will not. If a screen is required it will be of top quality wire wound stainless steel , which is installed at the proper depth for each well.
All wells are sealed to prevent any and all contamination to the water supply. A cement grout or bentonite seal is used for this process depending on the type of well. Iron, Nitrate and Ph testing is done on site. Samples are also taken and sent in to the state of Wisconsin to test for bacteria, which is required by state law.